< Back to the projects index

RoboComm

RoboComm is an experimental Robot 1200C control program which I wrote for Ralph, G1LXI, who still uses his Robot regularly. It runs only on a Windows 7 64-bit PC and requires a parallel printer port and a somewhat complex interface. The first (and so far, only) "production" interface - which was designed and built by Jack, G1NZH - works fine but my prototype does not perform as well. I am not planning to release this program for general use. 

The image below shows the main RoboComm screen with a testcard retrieved from the Robot 1200C:

RoboComm screenshot

< Back to the projects index

 

Powered by CouchCMS